Skip to main content

Common Mistakes People Make When Using Waterproof Dry Bags

    The Unnoticed Dangers of not using dry bags correctly

    You have recently purchased a new and shiny pair of Waterproof Dry Bags to your weekend kayaking adventure. You are sure that you are not going to lose your phone and spares in the river. Nonetheless, a dry bag itself is as good as the individual who has accepted it. You shut your gear up and draw the top down. You will know Dry Bag Usage Tips that protect your costly electronics in a package when you know how the waterproof seal works.

    The inability to clear the Sealing Strip

    This is one of the major Dry Bag Sealing Errors that occur prior to commencing rolling. Sand, dirt or any loose hair is likely to be trapped in the stiffening strip on the opening. Such small particles form microscopic holes in the seal. Under pressure, water can easily penetrate these minute holes. You need to clean the sealing part using a clean cloth or a thumb. Make sure that the strip of plastic or fabric is smooth all around. A single grain of sand will destroy the integrity of the closure.

    Rolling the Top Too Few Times

    Most individuals believe that a single or two folds are sufficient in preventing the water. It is a dangerous myth that gives rise to a lot of wet backpacks. The majority of manufacturers suggest three or more complete rolls to achieve a proper seal. Even experts recommend four rolls in case you are completely going to be drowned. The use of folds provides an added protection against moisture.


    Not to notice the Air Pocket Inside

    The correct amount of air in your bag is an important step in Waterproof Bag Care. Excessive air in it turns the bag into a huge balloon. This complicates the process of packing into a kayak or a bigger rucksack. More to the point, the high internal pressure may even cause the seal to be forced open in case the bag is squeezed. On the other side, however, there is just a bit of air, which comes in handy when you are on the water.

    Congesting the Main Compartment

    It is highly tempting to stuff all the final gears into one big bag. One of the main reasons why Dry Bag Sealing Mistakes are frequent and common is overstuffing. Three rolls at the top cannot be obtained when the bag is too full. It causes stress on the fabric and the buckle due to the strain caused by the gears within. This stress has the potential to cause the heat-welded seams to part in the long run. A dry bag should not be filled to exceed about seventy per cent of its total height.

    Failure to carry out Post Trip Maintenance

    It is not until you get home on the trail that Proper Waterproof Bag Care is over. Some leave their bags in wet and crumpled states in the corner of garages. This causes moulds and mildews to grow inside the lining. The waterproof fabric protective coat can eventually be molded away. It is advisable that you should always take fresh water and rinse your bags after using them in the salt water. Hang them in an enclosed place to dry.

    Reliance on a Single Layer as Electronics Company

    When you are sure how to use Dry Bags correctly, accidents may still occur. Something sharp in the bag may puncture a small hole in the side. One layer may not be sufficient in the case of high-value products such as phones or cameras. The most sensitive electronics are transported by smart adventurers with the “double bag” technique. Put your phone in a small dry pouch and put it in the main Waterproof dry bag. This offers secondary coating of safety in case of failure of the primary seal. It is a minor measure that offers gigantic satisfaction of mind when crossing rivers.

    Protect your electronics the smart way—visit our Instagram for waterproof dry bag care tips and outdoor safety advice.

    FAQs

    Is it possible to immerse my dry bag in water?

    The majority of the dry bags are created to withstand a few submersions and splashes,
    but not diving. They are based on trapped air and rolled cloth to remain dry.

    How many rolls shall I make for a good seal?

    And you must always make at least three tight rolls to get no water in at all.

    Why is my dry bag damp inside?

    This mostly comes about as a result of condensation or gear that had been wet when packed.

    Does this mean that I can machine my dry bag?

    No, you must only wash them in some mild soap and cold water.

    Is it important whether the bag is white or black?

    Light colours are more visible in case your bag has gone loose in the stream.

    Share the Post:

    Related Posts

    First Time Here? Enjoy Free Shipping on Us!

    This field is for validation purposes and should be left unchanged.

    LIMITED TIME OFFER

    First Time Here? Enjoy Free Shipping on Us!

    Join our list and get complimentary shipping on your first order — a little welcome gift from the Drench team.

    This field is for validation purposes and should be left unchanged.

    By subscribing, you agree to receive emails from Drench. You can unsubscribe anytime. View our Terms and Privacy Policy.